Yazarlar
Yayınlar
- MakaleYalnız künye2018THE GENERAL SOLUTION OF A LAYERED MEDIUM RESTING ON A RIGID FOUNDATION
Adiyaman, Gokhan; Öner, Erdal; Birinci, Ahmet
In this study, the general solution of a receding contact problem of layered medium resting on rigid foundation is considered. The layered medium consists of N homogeneous layer with varying material properties and heights. The contact surfaces can be receding or attached. The problem may include M receding contact surfaces. The layered medium is loaded with n concentrated loads transmitted by circular stamps and r distributed loads. The problem is reduced to integral equation system using elasticity theory and Fourier integral transform. The numerical solution of the system is done by using Matlab. A program is written to solve the problem given by the user with any geometry and loading. The program is tested with two studies from the literature and it was shown that the results are compatible.
AtıfWoS3
İncele - MakaleYalnız künye2018THE MOST APPROPRIATE EARTHQUAKE RECORD GROUPS FOR DYNAMIC ANALYSIS OF A BUILDING
Atmaca, Barbaros; Ergun, Mustafa; Ates, Sevket
In this paper, seven real earthquake records are scaled according to Eurocode 8 design acceleration spectrum by using SESCAP (Selection and Scaling Program). SESCAP is a scaling program based on time domain scaling method and developed by using MATLAB, GUI software. Real and scaled earthquake records are used for linear time history analyses of a six-storied reinforced concrete building modeled as spatial by SAP2000. Eurocode 8 allows the use of real earthquake records for linear and nonlinear time history analyses of structures. In the case of using three earthquake records in linear and nonlinear time history analyses, maximum results of structural responses are used for design of structures. If at least seven time history analyses are performed, the mean responses of the structures are taken into account rather than the maximum results. For the selection of maximum results of structural response from thirty five groups are created by calculating combination of threes of seven real and scaled earthquake records, and another group including all of the seven real and scaled earthquake records are created for selection of mean. Relative floor displacements along X axis of the building are preferred as structural response of the building in this study. It is seen that differences between mean value and maximum value of the relative floor displacements along X axis of the building induced by seven and three scaled earthquake records respectively are less than ones obtained from real earthquake records.
- MakaleYalnız künye2016ANALYSIS OF A LONG STRIP CONTAINING AN INTERNAL OR EDGE CRACK USING FEM
Yaylaci, Murat; Birinci, Ahmet; Adiyaman, Gokhan; Öner, Erdal
This paper presents the elastostatic plane problem of a long strip containing an internal or edge crack perpendicular to its boundaries. The plane problem consists of an infinitely long strip of thickness h. The infinitely long strip is loaded by uniformly distributed load and rests on two simple supports. It is assumed that the effect of gravity is neglected. The finite element model of the problem is constituted using ANSYS software and the two dimensional analysis of the problem is carried out. Normalized stress-intensity factors for the cases with internal and edge crack, and normal stress (sigma(x)) for uncracked layer case are obtained for various dimensionless quantities. Finally, the results obtained from the finite element analysis are verified by comparing with analytical ones and it is seen that the results from finite element analysis indicate a good agreement with the analytical solution.
AtıfWoS4İncele - MakaleYalnız künye2016EFFECT OF IN SITU EXOPOLYSACCHARIDE PRODUCTION ON SENSORY PROPERTIES OF TURKISH-TYPE FERMENTED SAUSAGE
Yilmaz, Mustafa Tahsin; Toker, Omer Said; Tatlisu, Nevruz Berna; Arici, Muhammet; Dertli, Enes
In this study, effect of in situ exopolysaccharide (EPS) production on sensory properties of Turkish-type fermented sausage (sucuk) was determined. Sausage mixes were prepared as four groups: (a) Control group, control sausage samples produced without LAB addition, with natural flora, (b) Strain 1 group, sausage samples produced by using Strain 1 (EPS+ Lactobacillus plantarum 162 R strain), (c) Strain 2 group: sausage samples produced by using Strain 2 (EPS+ Leuconostoc mesenteroides N6) and (d) Mixture group, sausage samples produced by using mixture of Strain 1 and Strain 2. These mixes were fermented at 14, 16 and 18 degrees C for 8, 12 and 16 days. Fermentation conditions remarkably affected the sensory properties of the sausage using different EPS producing EPS. These results of this study demonstrated the importance of in situ EPS production on final sensory properties of sausage.
AtıfWoS1İncele - MakaleYalnız künye2015DAMAGE DETECTION IN SIMULATED SPACE FRAMES USING GENETIC ALGORITHMS
Artar, Musa; Daloglu, Ayse T.
Genetic algorithms (GA) based finite element model updating are applied to predict damage location and severity in space frames. The changes in natural frequencies are used as dynamic indicators to describe damaged members. Objective functions including dynamic data provide minimization of dynamic differences between numerical model and simulated damaged model. The presence of damages in structural elements is identified by stiffness reduction as a reduction in modulus of elasticity. Reproduction, double-point crossover and mutation operators are used in GA optimization procedures. In this paper, different simulated examples having various damage scenarios are modelled in SAP2000 software to obtain the experimental dynamic data. In the last example, noise effect is taken into account in simulated damaged data. A program is developed in MATLAB software for numerical model updating based on all genetic algorithm procedures. Thus, the size and extent of simulated damages are determined by updated numerical model. Results obtained from examples show that GA optimization is a convenient method for damage identification.
AtıfWoS2İncele