Sürdürülebilir Kalkınma Amaçları
Yayınlar
- MakaleAçık Erişim2025Scopus SJRQ1Transient Plane Wave Transmission Through an N-Layer Multilayer Structure with Bianisotropic Behavior
Cem Hasar, Ugur; Kaya, Yunus; Korkmaz, Huseyin; Iliev, Teodor
An analysis based on electromagnetic reflection and transmission properties of multilayer structures are in general needed to get more information about their electromagnetic responses before their implementation for some specific applications involving absorption, shielding, and diagnosis. Such an analysis could be exercised by either frequency-domain or time-domain. While the former one is based on the steady-state response, the latter one is based on the transient response which thus provides more information about electromagnetic properties of multilayer structures. A procedure relying on a direct theoretical time-domain analysis is preferable to a time-domain analysis based on computational procedures such as the finite-time-difference-domain or the fast Fourier transform. In this study, a series presentation of transient plane wave transmission coefficient of N-layer composite structures involving bianisotropic behavior is derived for the first time in the literature in terms of reduced transmission coefficients (the concept of subregion). The wave matrix approach is applied for the theoretical analysis of the reduced transmission coefficient after application of the concept of subregion. Implementation of this concept to our problem is presented step-by-step to make a clear understanding of its application to bianisotropic multilayer structures. The derived reduced transmission coefficient is validated by different multilayer structures (different layer numbers, different layer lengths, and different polarizations) composed of individual layers whose electromagnetic responses are synthesized by the Lorentz dispersion model. Advantages and limitations of the derived formalism are also presented.
- MakaleAçık Erişim2025Scopus SJRQ1Quantification of Honey Adulteration Using a Planar Microstrip Metamaterial-Motivated Sensor and Software-Defined Radio
Cem Hasar, Ugur; Hasar, Hafize; Kaya, Yunus; Ozturk, Hamdullah; Korkmaz, Huseyin; Kosunalp, Selahattin; Iliev, Teodor; Tariqul Islam, Mohammad; Nayyeri, Vahid; Mustafa Ramahi, Omar
This work presents the application of a planar microstrip metamaterial (MM)-motivated sensor in the form of a split-ring resonator (SRR) for the detection and quantification of water adulteration in honey samples. The proposed sensor utilizes inexpensive software-defined radio (SDR) measurements, offering a cost-effective solution. Unlike previous MM sensors employing SRR configuration, our proposed MM-motivated sensor is integrated with a microstrip feedline and an additional vertical bar, enhancing its sensing capability. To enable accurate measurements, a simple calibration procedure based on baseline normalization is implemented, allowing for amplitude-only transmission measurements (|S-21|) using the SDR. A special sample holder was designed to increase the repeatability of measurements. We separately employ two postprocessing techniques, namely, the rolling average (RA) approach and the Savitzky-Golay (SG) filter, to effectively eliminate ripples in the measured |S-21| data obtained from the SDR. For validation and evaluation of the proposed sensor and postprocessing techniques, measurements of flower honey samples with water adulteration levels (delta ) up to 10% (mass-to-mass basis) were also performed using a vector network analyzer (VNA). The resonance frequency of |S21| is utilized as the basis for analysis. We establish a metric function (linear function) that correlates the shift in resonance frequency with delta. It is observed that this function fits to measured resonance frequency values with an R(2 )value greater than 0.96 for both postprocessing techniques with or without the sample holder. By inverting this function, we can predict delta with considerable accuracy for a given resonance frequency by using another linear function. It is observed that percentage variations between predicted and measured delta values are between 1.54% and 6.46% for testing samples with delta = 5% and delta = 7%.
AtıfScopus5WoS2OpenAlex5
İncele - MakaleAçık Erişim2024Scopus SJRQ1Simpler Reference-Plane-Invariant Method for Permittivity Extraction of Medium- or Low-Loss Dielectric Samples Using One-Port Measurements
Cem Hasar, Ugur; Ali, Husain; Kaya, Yunus; Stoyanov, Ivaylo
A microwave method is devised to extract relative complex permittivity (ϵr) of medium- or low-loss dielectric samples. It is simpler, non-iterative, reference-plane-invariant (RPI), and applicable for one-port waveguide measurements with short-circuit termination only. Besides, since it uses short-circuit termination reflection-only measurements, it is free from Fabry-Pérot resonances. Permittivity measurements of polyvinyl chloride (PVC) and polypropylene (PP) are performed at X-band (8.2-12.4 GHz) to examine the performance of the proposed method considering different scenarios involving inaccurate information of sample location in the cell and inaccurate knowledge of the sample thickness. Repeatability analysis is carried out to analyze the performance of the proposed method against other similar methods in the literature.
AtıfScopus6WoS5İncele