Sürdürülebilir Kalkınma Amaçları

• 1
• 1

• MakaleAçık Erişim2023Scopus SJRQ2/r/bayburt/11804
  Investigation of organic and inorganic matters removal from tannery wastewater using iron plate electrode by electrocoagulation process

  Bingül, Züleyha; Irdemez, Şahset; Kul, Sinan; Ekmekyapar Torun, Fatma; Demircioğlu, Nuhi

  In this study, COD, turbidity, total nitrogen, phosphate, sulphate, oil-grease and chromium removals from wastewaters taken from a local tannery using the electrocoagulation process were examined and the most suitable parameters for the electrocoagulation system were tried to be determined. Soluble iron plate electrodes were used as electrodes in the experiments. As a result of the studies carried out, the most suitable initial pH in uncontrolled pH was determined as pH = 4 and for controlled pH as pH = 5. In studies, the most suitable current density for iron electrodes was determined as 1.2 mA cm−2. Even if the increase in current density increased the amount of dissolved Fe, it negatively affected the removal efficiency. In addition, the turbidity of the wastewater was removed in 30 minutes, phosphate in 20 minutes and chromium in 15 minutes by 100%. During 60 minutes of operation, while 62.91% of TN, 87.8% of oil-grease were removed, sulphate was removed at the rate of 54.78%. In the studies, 1st and 2nd order kinetic equations for COD removal were examined and it was determined that removal kinetic is more suitable for 2nd order kinetics.

  AtıfScopus7·WoS4

  İncele
• MakaleYalnız künye2013Scopus SJRQ2/r/bayburt/12429
  Separation and pre-concentration of palladium(II) from environmental and industrial samples by formation of a derivative of 1,2,4-triazole complex on Amberlite XAD-2010 resin

  Serencam, Huseyin; Bulut, Volkan Numan; Tufekci, Mehmet; Gundogdu, Ali; Duran, Celal; Hamza, Sibel; Soylak, Mustafa

  A simple separation/pre-concentration method was developed for extraction of Pd(II) in various environmental samples, based on its adsorption of 4-phenyl-5-{[(4-phenyl-5-pyridin-4-yl-4H-1,2,4-triazole-3-yl)thio]methyl}-4H-1,2,4-triazole-3-thyol (PPTTMET) complex on Amberlite XAD-2010 resin in a mini column. The ligand has high affinity for Pd(II) among many other metals that are taken into consideration. The flame atomic absorption spectrometry is employed to determine the concentration of Pd(II). The optimum working conditions which were determined are as follows: 0.05 mol L-1 HNO3 as working medium, 1.0 mol L-1 HCI in acetone as elution solvent, 0.75 mg of PPTTMET amount and 750 mL of sample volume. The system was independent from the flow rates between 3.1 and 23.1 mL min-1. The Pd(II) adsorption capacity of Amberlite XAD-2010 resin was found to be 12.8 mg g-1 and the enrichment factor was calculated as 375. The method was successfully applied for the determination of Pd(II) in motorway dust samples, anodic sludge, gold ore, industrial electronic waste materials and various water samples.

  • 
  • 
  AtıfScopus17·WoS15·OpenAlex17

  İncele