Sürdürülebilir Kalkınma Amaçları

• 1
• 1

• MakaleYalnız künye2024Scopus SJRQ1/r/bayburt/11299
  Investigation of antibacterial activities of copper based multinary sulfide alloys

  Kurt, Hacer; Çekceoğlu, İlknur Aksoy; Acar, Eminegül Genc; Aslan, Emre; Ozel, Sultan Suleyman; Sarilmaz, Adem; Patir, İmren Hatay

  One of the nanomaterial-based antimicrobials, CuS, has emerged as a potential active therapeutic agent to combat biofilm infections, showing superior antibacterial activity with both photothermal and photodynamic effects under NIR illumination. To investigate the influence of transition metals on the antibacterial activity of CuxS, the antibacterial properties of shape- and phase- controlled copper-based multinary sulfide (M: CuxS (M: Mn, Zn and Ni)) nanostructures prepared by hot injection method were investigated against Gram-positive Staphylococcus aureus and Gram-negative Escherichia coli under NIR light irradiation. It has been shown that CuxS-based nanomaterials suppress bacterial growth under NIR light irradiation and that, in addition to their antibacterial activity, they also exhibit a remarkable ability to form biofilms. The antibiofilm efficacy of the M:CuxS (M: Mn, Zn and Ni) nanocomposites was significantly higher than that of bare CuS, resulting in biofilm inhibition with rates of 52.53 %, 62.24 % and 74.48 % on E. coli for Mn:CuxS, Zn:CuxS and Ni:CuxS, respectively. In addition, the biofilm of S. aureus was more affected by treatment with M:CuxS (M: Mn, Zn and Ni) nanocomposites, with biofilm activity of 64.15 %, 68.42 % and 87.35 % for Mn:CuxS, Zn:CuxS and Ni:CuxS, respectively. Ni:CuxS showed the highest antibacterial activity, which is attributed to smaller crystal and particle size and energy band gap, resulting in a larger number of nanoparticles per unit volume, a larger surface area and a stronger tendency to electrostatically bind to bacterial cell membranes, a faster ability to penetrate channels and stronger absorption in the NIR range. This work points the way for a broad application of CuS-based biocompatible synergistic antibacterial nanocomposites and can also serve as a guide for antibacterial/antibiofilm approaches as an alternative to conventional antibiotic treatments.

  AtıfScopus8·WoS8

  İncele
• MakaleYalnız künye2020Scopus SJRQ1/r/bayburt/12087
  Comparison of phenol removal with ozonation in jet loop reactor and bubble column

  Barlak, Melahat Semin; Degermenci, Nejdet; Cengiz, Ibrahim; Ucun Özel, Handan; Yildiz, Ergun

  This study aimed to remove phenol with ozonation in a jet loop reactor (JLR) and a bubble column (BC). In the first stage of the study, the mass transfer properties of JLR were determined and superiority over BC reactors were shown, and in the second stage, these reactors were used in phenol removal studies. At the same conditions, the volumetric mass transfer coefficient of JLR was 0.540 min-1, while this value was determined as 0.246 min-1 in the BC reactor. In phenol removal, the effects of initial phenol concentration, ozone dosage and pH on phenol and chemical oxygen demand (COD) removal were determined for both JLR and BC. While the pseudo-first rate constant for phenol removal in JLR at 221 mg/min ozone dosage was 0.1756 min-1, this value was only calculated as 0.1157 min-1 in the BC reactor. As a result, it has been shown that JLRs can achieve higher ozone gas transfer with lower energy consumption and perform more effective phenol and COD removal than BC reactors, especially at low pH and high ozone dosages.

  • 
  • 
  AtıfScopus40·WoS36·OpenAlex39

  İncele