Sürdürülebilir Kalkınma Amaçları
Yazarlar
- Erdem, O.(1)
- Gökçe, H.S.(1)
- Nehdi, M.L.(1)
- Tuyan, M.(1)
Yayınlar
- MakaleAçık Erişim2024Scopus SJRQ3Investigation of Hot Press and Cold Press Effects on Structural, Electrical and Magnetic Properties of Pyrene Added Bulk MgB2
Erdem, O.
In this paper, the effects of hot pressing and cold pressing on the superconducting properties of pyrene (C16H10) added bulk MgB2 were compared. For this aim, the polycrystalline disk-shaped MgB2 samples with addition of 4 wt % C16H10 powder were fabricated by a pellet/closed tube method at 850 °C, after hot pressing at 200 °C and cold pressing. The XRD and SEM results showed that although a-lattice parameters reduce for both C16H10 added samples, the average crystallite size increases after cold pressing because of the accumulation and inhomogeneous distribution of C in the MgB2 structure while it reduces for the C16H10 added hot pressed sample. The resistivity measurements showed that the increment of electron scattering is higher for the C16H10 added cold pressed sample than that of the C16H10 added hot pressed one which shows relatively better grain connectivity, and the Tc values of the samples are not appreciably affected by the pressing conditions. From the magnetisation measurements the in-field Jc values at 10 K and 5.5 T were obtained as 8.41 × 103 A/cm2, 1.62 × 104 A/cm2, 6.90 × 103 A/cm2 and the Hirr values while Jc = 100 A/cm2 at 20 K were obtained as 5.99 T, 6.55 T and 6.19 T for the pure sample and the C16H10 added hot and cold pressed samples, respectively. The higher Jc and Hirr values obtained for the C16H10 added hot pressed sample is because of the homogenous C substitution into MgB2 grains, as compatible with its lower Δρ value, and thus increased flux pinning ability.
- Derleme MakaleAçık Erişim2021Scopus SJRQ1Alkali-activated and geopolymer materials developed using innovative manufacturing techniques: A critical review
Gökçe, H.S.; Tuyan, M.; Nehdi, M.L.
The manufacturing of geopolymers and alkali-activated materials for precast and cast in-situ construction applications could be achieved using suitable production techniques, such as one-part production, pre-setting pressure and hot pressing, two-stage concreting, and 3-dimensional printing. Adequate selection and tailoring of the manufacturing methodology are imperative for overcoming characteristic application problems of these materials and achieving eco-efficiency and superior engineering properties. With distinctive benefits including rapid solidification, lower cost, saving natural resources, less energy consumption, and reduced carbon footprint, alkali-activated and geopolymer composites have emerged as a strong contender for replacing conventional concrete in diverse construction applications. Critical analysis of the literature on innovative production methods indicates that the one-part production technique is promising for the eliminating design complexity of these mixtures. The pre-setting pressure and hot pressing applications would allow the achievement of superior physical and mechanical characteristics in a short period of time, especially for the precast industry. The workability and setting problems of alkali-activated materials could be overcome using the two-stage concreting methodology. To be used in 3D printing of alkali-activated and geopolymer materials, remarkable development is required in terms of rheological aspects. Accordingly, this paper surveys pertinent and recent literature and critically reviews the state-of-the-art of alternative production techniques of alkali-activated and geopolymeric materials, along with its use in recent applications, identifies pertinent knowledge gaps, and defines future research directions.
AtıfScopus155WoS137OpenAlex167
İncele