Sürdürülebilir Kalkınma Amaçları

• 1

Yazarlar

• Uyar, Mehmet(2)
• Ergün, Mustafa(1)

• MakaleAçık Erişim2024/r/bayburt/16475
  Seismic behavior assessment of RC buildings controlled by passive and active techniques

  Uyar, Mehmet; Ergün, Mustafa

  In this paper, a numerical study was carried out on the effectiveness of the active earthquake control method in improving the earthquake response of RC buildings. High damping rubber bearing design was made according to the criteria of the Uniform Building Code. Three different types of isolators were obtained geometrically. Passive earthquake control of the building was provided by placing these isolators under the columns. For active earthquake control of the building, controller design was realized by integrating it into the FE transient analysis in ANSYS. The active earthquake control design was studied using a force-based and displacement-based controller with acceleration and displacement feedback. The linear dynamic earthquake analysis in the time history of all three states of the building (un-controlled, passive, and active-controlled) was made using the acceleration record of the Seferihisar (İzmir) earthquake. When the results are examined, it is seen that the active earthquake control method provides almost all of the positive behavior expected from the passive earthquake control method. In addition, it eliminates some of the disadvantages of the passive earthquake control method.

  • 
  AtıfOpenAlex1

  İncele
• MakaleAçık Erişim2023/r/bayburt/16574
  Study on dynamic modelling and vibration analysis of single-link flexible manipulator

  Uyar, Mehmet

  In this study, SimMechanics-based dynamic modeling and vibration analysis of a single-link flexible manipulator are studied. A flexible beam model is set up for modeling the manipulator. Transient analysis is performed to obtain the endpoint acceleration vibration responses of the manipulator moved with different motion profiles. Both the experimental and simulation acceleration results are presented for different cases. The root means square (RMS) values of the acceleration responses are calculated to evaluate the compatibility performance in verifying the simulation results with the experimental results. It has been observed that the results match each other successfully for different cases. The reliability of the SimMechanics-based dynamic modeling method of manipulators is discussed with the experimental results.

  AtıfOpenAlex3

  İncele