Yazarlar
Yayınlar
- MakaleAçık Erişim2019Scopus SJRQ3Investigation of Stress Corrosion Cracking Behaviour of Mg-Al-Zn Alloys in Different pH Environments by SSRT Method
Catar, Recep; Altun, Hikmet
In this study, stress corrosion behaviors of AZ31, AZ61 and AZ91 Mg alloys which contain different amounts of Al were investigated under acidic, basic and neutral environments having chloride ions using Slow Strain Rate Test (SSRT) method. Stress corrosion indexes (ISCC), ultimate tensile strength (UTS) and elongation of AZ31, AZ61, and AZ91 Mg alloys were determined and compared. Slow strain rate test showed that three Mg alloys in basic environments were the least stress corrosion susceptible, while the most stress corrosion susceptible occurred in acidic environments. Also, it has been shown that the stress corrosion indexes of AZ91 Mg alloys are less than AZ31 and AZ61 Mg alloys in all environments. UTS and elongation of AZ61 Mg alloys were higher than those of AZ31 and AZ91 in all media. The fracture of surface images also examined in the scanning electron microscope (SEM) and both intergranular stress corrosion cracking (IGSCC) and transgranular stress corrosion cracking (TGSCC) were observed in all three alloys.
AtıfScopus16WoS13OpenAlex14
İncele - MakaleYalnız künye2019Scopus SJRQ4Comparison of cationic dyes (basic orange 2, basic yellow 2 and basic violet 3) removal from aqueous solution using clay as an adsorbent
Farizoglu, Burhanettin; Fil, Baybars Ali; Sozudogru, Onur; Aladag, Erdinc; Kul, Sinan
The present work aims to investigate the removal of three cationic dyes (Basic Orange 2, Basic Yellow 2 and Basic Violet 3) from aqueous solutions by montmorillonite under various experimental conditions. Cationic dyes were selected Basic Orange 2 (BO2), Basic Yellow 2 (BY2) and Basic Violet 3 (BV3). The effects of pH, initial dye concentration, adsorbent dose, agitation speed and ionic strength, on the removal of dyes were studied. According to the experiments results, it was shown, that maximum removal was achieved in less than 45 min. The results indicate that the montmorillonite can be used as a low cost alternative according to other adsorbents in the removal of dyes from wastewater. The maximum adsorption efficiency levels attained were as follows: 95.849% BO2, 99.562% BY2 and 99.169% BV3 onto montmorillonite at pH: 5.0, 100 mg/L initial dye concentration, 0.75g/L clay dosage, 300 rpm agitation speed, 0 M NaCl ionic strength and 293 K, reaction time of 45 min.
AtıfScopus2İncele