Yazarlar
Yayınlar
- MakaleAçık Erişim2013Scopus SJRQ1Comparison of the effects of different types of tube inserts on two-phase flow instabilities
Omeroglu, Gokhan; Çomaklý, Omer; Karagoz, Sendogan; Karsli, Suleyman
Turbulence promoting inner elements such as rings, wings or winglets, twisted tapes, etc., is widely used in single- and two-phase flows. In this experimental work, the two-phase flow instabilities of forced convection boiling in a horizontal tube with ring- and twisted-tape-type inner elements inside are investigated. In order to analyze the two-phase flow of water, the experiments were conducted under a constant system pressure of 7.5 bar, and a constant heat input of 24 kW was applied to the outer surface of the circular test pipe with constant exit restriction. Three different inlet temperatures (Ti = 15, 25, and 35°C) were used to see the effect of inlet sub-cooling, and the mass flow rate was decreased from 110 to 20 g/s to obtain the characteristic curve. Two different pitch ratios for both the ring and twisted tape were evaluated in terms of stability. The results were evaluated in terms of appropriate variables for both the tube with insertions and the smooth tube. The analysis shows that the pressure drop increases with decreasing mass flow rate for all cases. The presence of the inner elements in the test pipe causes the boundaries of the oscillations to narrow in comparison with smooth tube. On the other hand, with the increase in the effective diameter of the test pipe the boundaries of the oscillations broaden. For each type of insertion, the increase of the pitch ratio makes the system less stable.
AtıfScopus4WoS3OpenAlex6
İncele - MakaleYalnız künye2012Scopus SJRQ2Forced convective two phase flow analysis in a circular tube equipped with twisted tapes
Omeroglu, Gokhan; Comakli, Omer; Karagoz, Sendogan; Manay, Eyuphan
In forced convection boiling systems, it is important to know the dynamic behavior for understanding and predicting the local and global stability of the system. Besides this, the instability phenomenon in the industrial processes in which two phase flow takes part becomes more of an issue. So, the mechanisms of instabilities and the ways of decreasing the stabilities are of interest of the researchers for a long time. In this study, the effects of pitch ratio, inlet temperature and the mass flow rate on two phase flow instabilities in a horizontal circular tube are investigated. The experiments are conducted under constant system pressure, and a constant heat input of 24 kW is applied to the outer surface of the circular test pipe having constant exit restriction. The results of two different pitch ratios are also compared with the smooth tube. For all investigated cases, the results are evaluated in terms of pressure drop type and density wave type oscillations. The time dependent measurements of top wall temperature, bottom wall temperature, inlet pressure and mass flow rate variations are also presented. The boundaries of the oscillations are found for both twisted tape and smooth channel. It is found that the unstable region of the flow extends while the distance between boundaries increases. It is observed that the system is more stable in the case of the lowest pitch ratio, and the increase of the pitch ratio causes system to be less stable. By the decrease of the inlet temperature, the single phase liquid region extends in the test tube and thus the system becomes more stable.