Sürdürülebilir Kalkınma Amaçları

• 1

• MakaleAçık Erişim2020/r/bayburt/14619
  Voltage Control of Cuk Converter with PI and Fuzzy Logic Controller in Continuous Current Mode

  Çorapsız, Muhammed Reşit; Çorapsız, Muhammed Fatih; Yilmaz, Mehmet

  In today's energy systems, many equipment operates with Direct Current (DC) voltage. However, it is not always possible to obtain the voltage level required for the operation of these equipment from standard power supplies. For this reason, DC-DC converters are used to achieve the desired voltage values for equipment with different DC voltage levels. These converters are divided into three general categories, named Buck, Boost and Buck-Boost. The most preferred converter is the Cuk converter with low output ripple voltage, which can operate in both buck and boost modes. In this study, a detailed analysis of the Cuk converter, which is frequently used in Photovoltaic (PV) Panels was performed and different control methods of the output voltage were proposed. While performing this analysis, the dynamic model of the Cuk converter was created in which, Proportional-Integral (PI) and Fuzzy Logic (FL) are used to control the output voltage of the Cuk converter. The performances of both controllers were compared with respect to performance parameters such as steady state error, settling time and rise time. When the results obtained were evaluated as a whole, it was observed that FLC achieved the desired reference with less rise and settling time. In this study, modeling and controller applications of Cuk converter are realized by using MATLAB / SIMULINK program.

  • 
  AtıfOpenAlex8

  İncele
• MakaleAçık Erişim2019/r/bayburt/15150
  Analysis and Suppressing Speed Fluctuations in Brushless DC Motors

  Çorapsız, Muhammed Reşit; Kahveci, H.; Fatih Çorapsız, M.

  The fluctuations in both speed and torque magnitudes during operation are among the major disadvantages of brushless DC motors. These fluctuations occur due to both the commutation of the inverter switches and the phase winding inductances. This case can lead to major problems, especially in applications which are required constant speed and constant torque. In this work, it was aimed to reduce speed fluctuations that occur in brushless DC motors. Firstly, the simulation model was created by using the dynamic equations of the brushless DC motor. Secondly, a region selective circuit was designed for use in commutation regions. Finally, the commutation signals were generated from the magnitude of the torque produced by the motor. Consequently, the proposed technique was controlled under different speed conditions and was shown that the speed fluctuations can be reduced without the difficult calculations of the commutation time. According to the results obtained, it was observed that the speed fluctuations were significantly reduced.

  AtıfOpenAlex3·TR Dizin1

  İncele