Pul, Selim; Ghaffari, Amir; Öztekin, Ertekin; Hüsem, Metin; Demir, Serhat

Various failure criterions have been used for the nonlinear analysis of concrete and reinforced concrete structures. To get more accurate results from the analyses, the selected failure criterion must be appropriate with the characteristics of problem and the assumptions made in the criterion should comply with the characteristics of problem. In this study, an experimental investigation was carried out to determine the cohesion (c) and internal friction angle (?) values, which are in the compressive strength range of 14.4 MPa ≤ fcm cube ≤ 47.0 MPa (2.03 ksi ≤ fcm cube ≤ 6.82 ksi) that are used in failure criterions such as Mohr-Coulomb and Drucker-Prager preferred in end unit analyses for concrete and reinforced concrete structures. Tests are performed by using the direct shear test system, which is designed and produced for this study. Finally, cohesion and internal friction angle were determined between 2.94 and 12.34 MPa (0.43 and 1.79 ksi) and 29.8 and 41.7 degrees, respectively.

AtıfScopus44·WoS38·OpenAlex36

İncele

Selcuk, Levent; Gökce, H. Suleyman; Kayabali, Kamil; Simsek, Osman

This study presents a practical nondestructive testing (NDT) method: the nail penetration test (NPT). The major tools of the test technique are a gas nailer with 130 J (95.88 ft-lbf) power, concrete nails, and a gas nailer cell. The study covers three different limestone aggregate types. Six concrete mixtures were prepared from each aggregate type. Five nail shots were performed on each concrete mixture (or grade) and the average value was obtained. The average nail penetration depths were correlated with the compressive strength of concrete. Other NDT techniques, such as the Schmidt rebound hammer (SRH), ultrasonic pulse velocity (UPV), and Windsor probe (WP), were also applied to concrete samples. The measured compressive strength values were compared with those obtained from the empirical relationships using the data from the NPT, SRH, UPV, and WP. It was found that the reliability of the NPT to estimate the compressive strength of concrete is very high. The tool employed in the investigation covers a relatively wide range of compressive strength of concrete. This testing tool is proposed to estimate the compressive strength of in-place concrete.

AtıfScopus15

İncele