Adiyaman, Gokhan; Oner, Erdal; Yaylaci, Murat; Birinci, Ahmet

This paper considers the continuous and discontinuous contact problems of a functionally graded (FG) layer under the effect of gravity. A finite distributed load is applied to the beam from the top and the beam is placed to the top of a rigid foundation. It is assumed that the shear modulus and mass density of the beam vary exponentially whereas Poisson's ratio remains constant. The problem is solved for both continuous and discontinuous cases. In each case, the governing equations and boundary conditions of the problem are reduced to an integral equation by the help of Fourier integral transform. In the continuous contact, the integral equation solved analytically and critical load that causes initial separation between the layer and the rigid foundation, separation distance and contact pressures are investigated for various non-homogeneity parameters that presents the change in the shear modulus and density and loadings. The singular integral equation in case of discontinuous contact is numerically solved by using corresponding Gauss–Chebyshev quadrature and an iterative scheme. The effect of non-homogeneity parameters and loading on the separation distance between the layer and the foundation and contact pressures are analyzed. All the results are shown in tables and figures. It is seen that increasing stiffness and decreasing density at the top of the layer reduce maximum pressures but increase separation distances. This study aims to fill the deficiency in the mechanical behavior of the coatings under gravity.

AtıfScopus19·WoS20·OpenAlex17

İncele

Öner, Erdal; Şengül Şabano, Bahar; Uzun Yaylacı, Ecren; Adıyaman, Gökhan; Yaylacı, Murat; Birinci, Ahmet

The frictionless double receding contact problem for two functionally graded (FG) layers pressed by a uniformly distributed load is addressed in this paper. The gradation in the layers is assumed to follow an exponential variation through the height with constant Poisson's ratios. The lower layer rests on a homogeneous half-plane (HP). There is no adhesion between the FG layers or between the lower layer and the HP. The body forces of the FG layers and HP are ignored. First, the governing equations are reduced to a system of two singular integral equations with contact pressures and contact lengths as unknowns using Fourier transform techniques and boundary conditions. The integral equations are solved numerically using the Gauss-Chebyshev integration formula. Then, a parametric finite element analysis is performed using the augmented contact method. Finally, the problem was extended based on the multilayer perceptron (MLP), an artificial neural network used for different problem parameters. The effects of stiffness parameters, the normalized load length, the ratio of shear moduli, the ratio of FG layer heights to the normalized contact lengths, and normalized maximum contact pressures are explored. The results of finite element analysis and the MLP approach are used to validate the normalized maximum contact pressures and contact lengths obtained from an analytical method based on elasticity theory, and finally, good agreement between these three methods results is obtained. The obtained results could help in designing multibody indentation systems with FGMs.

AtıfScopus85·WoS84·OpenAlex48

İncele